Lash like a pro

Follow our simple guides on how to apply, remove and clean your lashes — so you can become your own lash tech.

 Buy now

Guides

Application

Step 1: Curl & Bond

Curl your natural lashes with the lash curler and apply a thin layer of Bond at the roots of your lashes and to the band of your lash cluster.

Step 2: Lash up

Wait 30-60 seconds for the product to get tacky, then place your lash clusters underneath your upper lashes, approximately 1-2 mm from the lash line. Let them overlap slightly for an even, gap-free result.

Step 3: Squeeze & Seal

Use the lash applicator to gently press the lashes together. Finish by applying Seal on both sides to lock them in place.

Removal

Step 1:

Apply a generous amount of Lash Cluster Remover to your lash clusters and leave on for 3-5 minutes before gently removing them.

Step 2:

Reapply Lash Cluster Remover to both sides of your natural lashes and leave on for 1-2 minutes to remove any remaining adhesive residue.

Step 3:

Finish by thoroughly cleaning your lash clusters so they can be reused.

Cleaning & Reuse

Step 1:

Place your removed lash clusters on a clean surface and apply a small amount of Lash Cluster Remover to the lash bands to dissolve any remaining adhesive residue.

Step 2:

Leave the product on for 1-2 minutes, and then gently remove the adhesive residue with clean tweezers or your fingers. Avoid pulling directly on the lash fibers.

Step 3:

Clean the lashes with water and let them air dry completely. Repeat the process until you’re satisfied with the result.

Once the lashes are completely clean and dry, place them back in their original box until the next wear.